Wayne-Dalton 8800 - Manual (Page 16)

16
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
Tools Needed:
Tools Needed:
To install horizontal track, place the curved
end over the top roller. Align the bottom of the
horizontal track with the vertical track. hand
tighten the horizontal track to the flagangle/wall
angle with (2) 1/4”- 20 x 5/8” carriage bolts
and (2) 1/4”- 20 flange hex nuts.
Level the horizontal track assembly and bolt the
horizontal angle to the slot in the flagangle/wall
angle using (1) 3/8”- 16 x 3/4” hex head bolt
and (1) 3/8” - 16 hex nut. Repeat for other side.
Remove the nail that was temporarily holding
the top section in place, installed in Step 13.
imPoRTaNT: FAILURE TO REMOVE NAIL
BEFORE ATTEMPTING TO RAISE DOOR
COULD CAUSE PERMANENT DAMAGE TO
TOP SECTION.
DO NOT RAISE DOOR UNTIL
hORIzONTAL TRACKS ARE SE-
CURED AT REAR, AS OUTLINED
IN STEP 23, OR DOOR COULD
FALL FROM OVERhEAD POSI TION
CAUSING SEVERE OR FATAL INjURY.
Tools Needed:
15
14
With tracks installed you can adjust the top
brackets. Vertically align the top section
of the door with the lower sections. Once
aligned, position the roller in the top bracket
slide, out against the horizontal track.
Maintaining the slide’s position, tighten
the (1) 3/8” - 16 hex nut to secure the top
bracket slide to the top bracket base. Repeat
for other side.
adjusting Top brackets
7/16” Wrench
Step Ladder
hORIzONTAL
TRACK
TOP BRACKET
SLIDE
CORRECT
INCORRECT
TOP ROLLER
TOP
SECTION
TOP
SECTION
TOP
SECTION
waRNiNg
(1) 3/8”- 16 x 3/4”
hEx hEAD BOLT
(1) 3/8”- 16
hEx NUT
hORIzONTAL
TRACK
hORIzONTAL
ANGLE
FLAGANGLE
(2) 1/4” FLANGE
hEx NUTS
VERTICAL
TRACK
hORIzONTAL
TRACK
(2) 1/4” x 5/8”
CARRIAGE
BOLTS
9/16” Socket
7/16” Socket
Ratchet Wrench
9/16” Wrench
Level
hammer
Step Ladder
attaching horizontal Track to
adjustable Flagangle and wall
angle
FLAGANGLE
(1) 3/8”- 16 x 3/4”
hEx hEAD BOLT
(1) 3/8”- 16
hEx NUT
WALL ANGLE
hORIzONTAL
TRACK
hORIzONTAL
ANGLE
3/8” - 16
hEx NUT
1-3/4”