Wayne-Dalton 8800 User Manual

Page 14

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your

local yellow pages/business listings or go to the

Find a Dealer section online at www.wayne-dalton.com

Tools Needed:

Stacking Sections

Power Drill

7/16” Socket

Driver

LOCK SECTION

NoTe: For door section identification see page 4.

NoTe: Make sure hinges are flipped down, when

stacking another section on top.

With assistance, lift second section and guide
roller into the left vertical track. Stack this
section into the opening by hooking the roller
into the left hand vertical track and lowering
the section onto the bottom section, as shown.
Insert a roller into the proper, uninstalled right
hand end hinge, and place the roller into the
right hand vertical track. Lower the roller and
hinge into the proper position over the section,
and attach to the section in the same manner
the left hand end hinge was attached in step 7.

Keeping the ends of the sections aligned, install

remaining section(s), except top section, in same

manner. Now flip up hinge leaf, hold tight against

section, and fasten center hinges first, and end

hinges last, using (2) 1/4” x 7/8” self drilling

screws. Repeat for other section(s) except top

section.

imPoRTaNT: PUSh & hOLD ThE hINGE LEAF

AGAINST SECTION WhILE SECURING WITh 1/4” x

5/8” SELF TAPPING SCREWS.

NoTe: Install lock at this time (sold separately)

see instructions in OPTIONAL SIDE LOCK

INSTALLATION on page 24.

Position the left hand vertical track assembly

over the rollers of the bottom section. Make

sure the counterbalance cable is located

between the rollers and the door jamb. Drill

3/16” pilot holes for the lag screws. Loosely

fasten the vertical track assembly to the jamb

using 5/16” x 2” lag screws. Tighten

bottom lag screw securing vertical track

assembly to jamb, to maintain 5/8” spacing.

Repeat for the right hand side.

Tighten the 1/4” x 5/8” carriage bolts and 1/4”

flange hex nuts of each clip plates.

hang counterbalance cables over vertical track

assemblies.

WALL ANGLE

hOLE

SELECTION

5/16” x 2”

LAG BOLT

WALL

ANGLE

VERTICAL

TRACK

vertical Track and wall angle

installation continued....

VERTICAL TRACK

ROLLER

3/8 -

5/8”

WALL ANGLE

5/16 x 2” LAG

SCREWS

WALL ANGLE

ASSEMBLY

BOTTOM

SECTION