VIEWSONIC PJ1065 - Manual (Page 16)

14 ViewSonic PJ1065
Image Menu
The following adjustments and settings are available when IMAGE is
selected on the menu. Select an item with the and buttons, and start
or stop operation with the and buttons.
Table 6: Image Menu
Item Description
BLANK
Select Blank Screen: Select the screen with the / button. The selected one
(MyScreen, ORIGINAL or one colors) is displayed when the BLANK mode is ON.
MyScreen is a mode that the customer-customized screen is displayed. This is
the blue screen at the factory setting. Refer to the description of MyScreen below.
ORIGINAL is a mode that the factory fixed screen is displayed.
• When MyScreen or ORIGINAL is selected, the screen is going blank after
several minutes.
START UP
Select Start Up Screen: Select the screen in case of no signal input with the /
button. The selected one (MyScreen, ORIGINAL or TURN OFF) is displayed
when no signal is input
MyScreen is a mode that the customer-customized screen is displayed. This is
the blue screen at the factory setting. Refer to the description of MyScreen below.
ORIGINAL is a mode that the factory fixed screen is displayed.
TURN OFF displays the blue screen.
• When MyScreen or ORIGINAL is selected, the screen is going blank after
several minutes.
MyScreen
Set MyScreen Mode: Select the EXECUTE with the button to display the
MyScreen menu and set the MyScreen mode for BLANK and START UP
functions.
ESC clears and closes the menu box.
NORM. is default of the MyScreen menu.
FREEZE freezes the image and displays the frame to capture.
Press the button after freeze to go to the MyScreen Capture Position mode.
In the MyScreen Capture Position mode, the buttons , , and allow to
move the frame to capture.
After adjusting the position, press the KEYSTONE button to go to the MyScreen
Display Size mode.
To cancel freezing and return to the NORM. Mode of the MyScreen menu, press
the RESET button.
In the MyScreen Display Size mode, select the magnification x1, x2 or FULL with
the button .
After selecting the magnification, press the KEYSTONE button to go to the CAPT.
mode and start capturing.
To return to the MyScreen Capture Position mode, press the RESET button.
CAPT. executes a capturing the image. It requires about 20 seconds. After
capturing, the captured image will be displayed for about 10 seconds.
MIRROR Select Mirror Status: Select mirror status with button.
P. IN P.
POSIT
Select Position of P. in P. Display: Press the button.
• Valid only at RGB IN 1, RGB IN 2 or DVI input.
P. IN P.
INPUT
Select signal of P. in P. Display: Press the button.
VIDEO S-VIDEO COMPONENT
GAMMA
Select Gamma Mode: Select the gamma mode with the button.
NORMAL CINEMA DYNAMIC