VIEWSONIC PJ1065 - Manual (Page 15)

ViewSonic PJ1065 13
Input Menu
The following functions are available when INPUT is selected on the
menu. Select an item with the and buttons, and start or stop operation
with the and buttons. The function indicated (**) are effective on
video input mode, the P.IN P. window on RGB input mode.
Table 5: Input Menu
Item Description
AUTO
Automatic Adjustment at RGB Input: Select the EXECUTE with the button.
Horizontal position (H.POSIT), vertical position (V.POSIT), clock phase
(H.PHASE), and horizontal size (H.SIZE) are automatically adjusted. Use with
the window at maximum size in the application display.
Automatic Adjustment at Video Input: Select the EXECUTE with the
button. A signal type appropriate for the input signal will be selected
automatically. Valid only when AUTO is set for VIDEO on the menu.
• This operation requires approximately 10 seconds. It may not function correctly
with some input signals. Pressing the AUTO button in this case may correct this
problem.
• This function is the same as for the AUTO function in Basic operation.
RGB
Displays RGB Input Frequency: Displays the horizontal and vertical sync
signal frequencies for RGB input.
• Valid only at RGB input.
VIDEO (**)
Select Video Signal Type: Select the signal type with the and buttons.
Select NTSC, PAL, SECAM, NTSC4.43, M-PAL, or N-PAL as appropriate for the
input signal. The selection of AUTO enables and executes the function AUTO
(Automatic Adjustment at Video Input), except for the N-PAL input.
• Use this function when the image becomes unstable (eg. the image becomes
irregular, or lacks color) at VIDEO/S-VIDEO input.
• Automatic Adjustment requires approximately 10 seconds. It may not function
correctly with some input signals. Pressing the AUTO button in this case may
correct this problem except for the N-PAL input.
• For the COMPONENT VIDEO input, this function is not effective and the signal
type is distinguished automatically.
VIDEO NR
(**)
Set/Clear Noise Reduction Mode: Select the TURN ON / TURN OFF with the
button. When the TURN ON is selected, the NR mode is active and the
noise on screen of the video input will be reduced.
• Valid except for the HDTV.
Progressive
(**)
Select Progressive Mode: Select the mode suitable for the input signal with the
buttons. The TV mode and the FILM mode convert the interlaced video
signal into the progressive signal. The FILM mode is adaptable 2-3 Pull-Down
system to the conversion.
• Use this function to raise resolution, at the interlaced video input except HDTV
signal.
BLACK **)
Set/Clear Black Enhancement Mode: Select the TURN ON / TURN OFF with
the button. When the TURN ON is selected, the black enhancement
mode is active and the contrast ratio of the screen for the video input will be
raised by making black level darker.
HDTV (**)
Select HDTV mode: Select the 1035i mode or 1080i mode suitable for the input
signal with the button.