VIEWSONIC PJ1065 - Manual (Page 10)

8 ViewSonic PJ1065
Power Connection
Be sure to use the correct supplied power cords depending on the power outlet to be connected to.
Connect the AC inlet of the projector firmly to the power outlet with the power cord.
CAUTION
• Be careful when you handle the power cord.
• Firmly connect the power cord. Do not use a loosened or
unsafe power outlet or a malfunctioning contact.
Example of system setup
NOTE: • When connecting the projector to a notebook computer, set it so as to activate the RGB
external image output (setting it to CRT display or to simultaneous LCD and CRT display). For more
information, refer to the instruction manual of the notebook computer.
Plug & Play
This projector is compatible with VESA DDC 1/2B. Plug & Play is possible by connecting to a com-
puter that is compatible with VESA DDC (Display Data Channel).
Use this function by connecting the accessory RGB cable with RGB IN 1 terminal (DDC 1/2B com-
patible), or by connecting an optional DVI cable with DVI terminal (DDC 2B compatible). Plug &
Play does not operate by any other connection.
NOTE:
• Plug & Play is a system configured with peripheral equipment including a computer and display,
and an operating system.
• This projector is recognized as a Plug & Play monitor. Use the standard display drivers.
• Plug & Play may not function properly with the computer to be connected. Use the RGB IN 2
terminal if Plug & Play does not function correctly.
Power outlet
AC inlet
Power cord
Computer
(desktop)
S-Video Tape
Recorder
Computer
(notebook)
Display
Monitor
DVD Player
Speaker
with
amplifier
Computer (desktop)