Uniden ANA9620 - Manual (Page 17)

Programming Functions
PBX OR PSTN
In the Programming mode, you can select either Analog PBX or
PSTN (Public Service Telephone Network) operation. The default
is PSTN.
Available features of each mode of operation are illustrated in the
table below.
Feature Analog PBX PSTN
Conference Conference by PBX Connect Lines 1 & 2
Transfer Transfer by PBX Not Available
PROGRAM MODE SETUP
To enter the Program mode, perform the following steps:
1. At Standby, press and hold the
, keys. While holding the
and keys, press and hold
the
talk
key until a short beep is
heard and the handset LCD displays:
2. Press the
chan
or
vol
keys to switch between and PSTN Analog
PBX modes.
3. Press the
talk
key to enter your selection
into memory. The handset LCD displays:
The phone returns to Standby.
For operation in PSTN mode, see page 19. For operation in
PBX mode, see page 17.
$
PR
OG
RA
MMI
NG
FU
NC
TI
ONS
Note: Both Conference and Transfer commands must be
programmed to their respective keys before these
features can be used.
#
#
C:\ana9620-1\ANA9620-1.vp
Fri Jul 31 12:35:42 1998
Color profile: Disabled
Composite Default screen