Uniden ANA9620 - Manual (Page 12)

CHARGING SECOND BATTERY
The charger unit of your ANA9620 is equipped to charge
the second battery with or without the handset in the front
slot.
1. Slide the second battery into the second
slot in the charging unit until the retaining clip
snaps over the top of the battery.
2. Make sure the
CHARGE 2
indicator
lights. If the
CHARGE 2
indicator
doesn’t light, check to see that the
AC adapter is plugged in, and that
the battery is making good contact
with the charging unit.
3. When charging is complete, the
CHARGE 2
indicator goes
off. Press the latch to remove the battery. If you don’t need
the battery immediately, leave it in the charging
compartment; it will not overcharge. If you place a fully
charged battery in the
CHARGE 2
slot, the
CHARGE 2
LED
lights briefly when you insert the battery.
4. You can replace the ANA9620 battery during a call. You
have up to 20 seconds to replace the battery.
LOW BATTERY INDICATOR
When the handset battery is low
and needs to be charged, you will
see the
batt low
icon in the display.
On A Call In Standby Mode
Only the talk button operates. None of the buttons operate.
Handset beeps once every 3
seconds.
Handset beeps every 15 seconds
Complete your call as quickly
as possible
Cannot make call.
Replace battery within
20 seconds to continue call.
Replace battery before making
a call.
Return the handset to the charging unit for charging or
replace the handset battery with another charged battery .
SETTI
N
G
U
P
NOTE
Charge the battery without
interruption for 5 hours.
batt low
IMPORTANT
You can leave the second
battery in the second slot. It
will not overcharge.
C:\ana9620-1\ANA9620-1.vp
Fri Jul 31 12:35:27 1998
Color profile: Disabled
Composite Default screen