Uniden ANA9620 - Manual (Page 11)

INSTALLING THE BATTERY
1. Remove the battery
cover by pressing
the latch and
sliding the cover
down and off of
the handset.
2. Slide the battery
down into the
handset.
3. Place the cover
and slide the cover
up until it latches
into the handset.
CHARGING THE BATTERY
The rechargeable sealed lead-acid battery must be fully
charged before using your ANA9620 for the first time.
1. Place the handset in the front slot of the charging unit.
2. Make sure the
CHARGE 1
indicator
lights. If the
CHARGE 1
indicator
doesn’t light, check to see that the
AC adapter is plugged in, and that
the handset is making good contact
with the charging unit . Two charge
pockets are available on the
ANA9620, with separate indicator
lights for each. The handset battery
and the second battery may be
charged simultaneously.
!
Use only the sealed
lead-acid battery
(part # BT9000) supplied
with this phone.
NOTE
Charge the battery without
interruption for 5 hours.
NOTCH
Note: The ANA9620 has a low battery protection
system which allows the battery to be replaced while in
operation, as long as it is replaced within 20 seconds.
NOTE
The Charge 1 indicator
light does not go off,
even when the charge
is complete.
C:\ana9620-1\ANA9620-1.vp
Fri Jul 31 12:35:26 1998
Color profile: Disabled
Composite Default screen