Uniden DCT5280 - Manual (Page 56)

T H E I N T E G R AT E D A N S W E R I N G D E V I C E [ 54 ]
Setting the Time
Follow these steps to set the clock on the answering system to the correct time.
1) Press CLOCK/MENU.
2) Press
/SELECT or /SELECT until the correct day is announced and the
corresponding number (from “ ” Sunday to “ ” Saturday) appears.
3) Press SET to select the day.
4) Press
/SELECT or /SELECT until you hear the correct hour setting.
The numbers “ ” through “ ” appear on the base as each hour is announced.
5) Press SET to select the hour.
6) Press
/SELECT or /SELECT until you hear the correct minute setting.
The numbers “ ” through “ ” appears on the base as each minute is announced.
7) Press SET to select the minute.
8) Press
/SELECT or /SELECT until you hear the correct AM or PM setting.
The message counter displays “ ” or “ ”.
9) Press SET to select the AM/PM setting.
A confirmation tone sounds, the day and time you set are announced for your review.
Setting a PIN code
To play your messages from a remote location, you will need to enter a two-digit
Personal Identification Number (PIN) code (
- ). To select a PIN code, perform
the following steps:
1) Press CLOCK/MENU twice. The current PIN code appears on the base
and it is announced.
2) Press /SELECT or /SELECT until the desired number appears. Press and hold
/SELECT or /SELECT to quickly scroll through the numbers on the display.
3) Press SET to select the PIN code.
A confirmation tone sounds, the system announces the new PIN code.
• Normally, if the
system remains idle
for 10 seconds after
/SELECT or
/SELECT is
pressed, the system
will return to standby.
However, for setting
the time, the idle
time is extended to
two minutes.
• Press and hold
/SELECT or
/SELECT to
quickly scroll through
the numbers on
the display.
• Time stamp will not
be heard until you
have set the time.
DCT5280_UP302BH UP01302BA_1 5/23/03 1:56 PM Page 54