Uniden DCT5280 - Manual (Page 46)

P H O N E B O O K [ 44 ]
Chain Dialing
The memory locations in the handset are not limited to phone numbers. You can also
store a group of numbers (up to 20 digits), that you need to enter once your call
connects. This is referred to as Chain Dialing.
An example of this is a bank account number. Store a special number in the phonebook
location (refer to “Storing Phone Numbers, Names, Distinctive Rings and Speed Dial”
on page 38). Once you have called your bank, and when you are prompted to enter the
account number, just as you do when viewing the phonebook location, view the special
number, then press the DIAL soft key.
a. Editing the Stored Data
1) When the phonebook location to be edited appears,
press the EDIT soft key. “Store/Edit Name” appears.
2) Follow the steps 4 to 8 under “Storing Phone
Numbers, Names, Distinctive Rings, and Speed Dial”
on page 39 to complete the editing operation.
3) Press the OK soft key. You will hear a confirmation tone.
b. Deleting the Stored Data
1) When the phonebook location to be deleted appears, press the DELETE soft key.
“Delete Memory?” appears.
2) Press volume/ ▲ to move the pointer to “Yes”.
3) Press the OK soft key. You hear a confirmation tone. “Deleted!” appears in the display.
S t o r e / E d i t N a m e
BACK DELETE OK
M o v i e s
D e l e t e M e m o r y ?
Y e s
N o
BACK BACK OK
3) Press volume/ ▲ or ▼ , or the number keypad to view the phonebook locations
(see “Viewing the Phonebook” on page 42).
DCT5280_UP302BH UP01302BA_1 5/23/03 1:56 PM Page 44