Uniden DCT5280 - Manual (Page 32)

G E T T I N G S TA R T E D [ 30 ]
Setting the Dial Mode
1) Enter the “Global Setup” menu, then the “Dial Mode” submenu
(see “Entering the Menu” on page 23).
2) Press volume/ ▲ or ▼ to change the selection, “Tone”
or “Pulse” (the initial setting is Tone).
3) Press the OK soft key. You will hear a confirmation tone.
System Reset
De-register the Handset
1) Enter the “System Reset” menu, then “Deregister HS” submenu
(see “Entering the Menu” on page 23).
2) Press volume/ ▲ or ▼ to select the handset ID to be
de-registered from the list, then press the OK soft key.
3) Press the OK soft key. You will hear a confirmation tone.
When de-registration is complete, “Deregistration
Complete” appears.
4) After de-registering the handset, move to “Replacing
the Base Setting” below.
Replacing the Base Setting
1) Enter the “System Reset” menu, then “Replacing
Base” submenu (see “Entering the Menu” on page 23).
“Do you want to replace Base?” appears.
2) Press the OK soft key. You will hear a conformation
tone. The base information will be deleted.
D i a l M o d e
T o n e
P u l s e
BACK BACK OK
W h i c h H a n d s e t ?
H a n d s e t # 1
H a n d s e t # 2
BACK BACK OK
A r e y o u s u r e
t o d e r e g i s t e r
H a n d s e t # 1 ?
BACK BACK OK
D o y o u w a n t t o
r e p l a c e B a s e ?
BACK BACK OK
When replacing the base is complete, “Please Register” appears, register the
handset(s) to the new base (see page 65).
DCT5280_UP302BH UP01302BA_1 5/23/03 1:55 PM Page 30