Uniden DCT5280 User Manual
Page 54
T H E I N T E G R AT E D A N S W E R I N G D E V I C E
[ 52 ]
Choosing between the two outgoing messages
When the phone is in the standby mode, press greeting. Press greeting again when the
outgoing message is played. Each time greeting is pressed, the outgoing message is
switched between the pre-recorded and the personal outgoing message.
Deleting an outgoing message
To delete the personal outgoing message, press
del while the message is playing.
The system announces “Greeting has been deleted”.
Setting the base ringer volume
You have four ringer volume options. One allows you to turn the base ringer off. The
other three are volume levels.
1) When the phone is in the standby mode, press ringer/vol
▲
or
▼
. You hear the ringer
at the current volume level (“ ” High, “ ” Medium, “ ” Low, or “ ” Off) (if you set
the base ringer volume to off “Ringer Off” is announced), and it appears on the base.
2) Press ringer/vol
▲
or
▼
repeatedly until the desired ringer volume appears. You will
hear a ringer at the selected volume level. The system returns to the standby mode.
You can also set the base ringer volume or while the phone is ringing, press ringer/vol
▲
or
▼
repeatedly to select the desired ringer volume.
• If an outside call is
received during the
operation, the
operation is canceled.
• If you press
ringer/vol
▲
in the
maximum volume level
(3) or ringer/vol
▼
in the ringer off (0),
you will hear a beep.
DCT5280_UP302BH UP01302BA_1 5/23/03 1:56 PM Page 52