Uniden DCT5280 - Manual (Page 31)

G E T T I N G S TA R T E D [ 29 ]
GETTING ST
ARTED
Global Setup
Setting Day and Time
1) Enter the “Global Setup” menu, then the “Day &
Time” submenu (see “Entering the Menu” on page 23).
2) Press volume/ ▲ or ▼ to select the day of the week,
then press the NEXT soft key.
3) Press the number keypad (0-9) to set the time, then press the NEXT soft key.
4) Press volume/ ▲ or ▼ to choose “AM” or “PM”, then press the OK soft key.
You will hear a confirmation tone.
Setting CIDCW
1) Enter the “Global Setup” menu, then the “CIDCW”
submenu (see “Entering the Menu” on page 23).
2) Press volume/ ▲ or ▼ to select “CW On/CWDX On”,
“CW On/CWDX Off”, or “CW Off/CWDX Off”, then
press the OK soft key. You will hear a confirmation tone.
Setting the Area Code
1) Enter the “Global Setup” menu, then the “Area
Code” submenu (see “Entering the Menu” on page 23).
2) Press the number keypad (0-9) to enter a 3-digit
area code.
3) Press the OK soft key. You will hear a confirmation tone.
D a y & T i m e
S U N 1 2 : 0 0 A M
BACK BACK NEXT
OK BACK
C I D C W
C W O n / C W D X O f f
C W O f f / C W D X O f f
A r e a C o d e
BACK OK
When the area code has already been stored in memory, the stored area code will be displayed.
To change it, use the DELETE soft key and number keys to enter the new area code.
• You can set the
clock either by the
handset or base
(see “Setting the
time” on page 54).
• When a Global
setting is changed
from one handset,
this affects all
registered handsets.
• For setting the day
and time, the idle
time-out is extended
to 2 minutes.
DCT5280_UP302BH UP01302BA_1 5/23/03 1:55 PM Page 29