Tut Systems XL-12000S - Manual (Page 43)

XL-12000S
MANAGED, HIGH-SPEED NETWORK MODEM USER GUIDE
7.0 CONFIGURE THE MODEM TUT SYSTEMS 35
FIELD DESCRIPTION
Subnet mask: Enter the Subnet mask for IP address.
Default gateway: Enter the IP address of the default gateway to which
the modem LAN interface is connected.
7.2.3.5 Telnet Setup
Use the following procedure to initiate a Telnet session once the
initialization procedures described earlier in this section are complete.
Verify that a physical connection exists between the 10Base-T modem
port on the modem and a network device by pinging the LAN
address of the modem. Open a Telnet session using the IP address
of the modem that you set in the “LAN IP Address” field in the
“Modem Management” screen.
The user interface for a Telnet or serial connection is the same. The
first screen is the Login Display screen. Press to proceed to
the Main Menu.
7.2.3.6 Modem Configuration
This section describes configuration options for the modem including:
• Master/Slave
• Modem Name
• Routing/Bridging Mode
• IP Addressing for both interfaces
• Static routing table entries
The values you will enter are dependent upon your pre-planned
network configuration.
Access to the Modem Configuration screen by pressing “C” from the
Main Menu.