Tut Systems XL-12000S - Manual (Page 21)

XL-12000S
MANAGED, HIGH-SPEED NETWORK MODEM USER GUIDE
7.0 CONFIGURE THE MODEM TUT SYSTEMS 13
1. Go to the Call menu and select connect. You will see the
Serial Session/Version ID screen (Figure 7.1).
m. To verify that you have correctly configured your PC’s
serial port, press the key and the XL-12000S
Login Display screen (Figure 7.8) should appear.
n. If your terminal remains blank, press and enter
again. If it is still blank, make sure you have entered the
correct settings in step seven above. Verify that you are
using the correct cable and have a good connection. If you
are still unable to view the Login Display screen, refer to
section 10.0, “Troubleshooting”.
Figure 7.1 Serial Session/Version ID Screen
2. When Login is displayed press . Ignore the request for
a password. (Screen shots for this process are contained in sec-
tion 7.8 and Appendix B)
3. In the Main Menu, select “C”.
4. In modem configuration change “Slave” to “Master” by typing
“M” in the Master/Slave field to designate this modem as the
Master. Press and this modem is now the Master.