Tut Systems XL-12000S User Manual
Page 31
XL-12000S
MANAGED, HIGH-SPEED NETWORK MODEM USER GUIDE
7.0 CONFIGURE THE MODEM
TUT SYSTEMS
23
The static routing table fields in the Modem 1 Configuration would be:
Destination
Mask
Gateway
Hops
192.168.4.0
255.255.255.0
192.168.3.2
1
For Modem 2:
The “LAN IP address” field in the Modem Configuration screen will
be set to 192.168.4.1
The LAN “Subnet Mask” field in the Modem Configuration screen
will be set to 255.255.255.0
The “DSL IP address” field in the Modem Configuration screen will
be set to 192.168.3.2
The DSL “Subnet Mask” field in the Modem Configuration screen
will be set to 255.255.255.0
The “Master/Slave” field in the Modem Configuration screen will be
set to Slave.
The “Routing/Bridging” field in the Modem Configuration screen
will be set to ip_routing_only
The static routing table fields in the Modem 2 Configuration would
be:
Destination
Mask
Gateway
Hops
192.168.2.0
255.255.255.0
192.168.3.1
1
3. Bridge Non-IP
This selection will enable the modem to route IP traffic and bridge
non-IP traffic at the same time. The modem passes only IP packets
between networks attached to the LAN and DSL sides of the modem
and networks designated in the modems static routing tables.
Bridge non-IP example: This example shows how the XL-12000S
routes IP packets. However, the Macintosh can still use the Apple
printer located in another building because non-IP packets
(AppleTalk) are bridged across the DSL line.