Texas Instruments TI-73 EXPLORER - Manual (Page 274)

268
Chapter 13: Link and the CBL àCBR Application
APPS.DOC Chapter 13: Link and CBL/CBR Application, English Julie Hewlett Revised: 02/07/01 10:34 AM
Printed: 02/07/01 10:35 AM Page 268 of 22
MIN and MAX
MIN and MAX refer to the minimum and maximum UNIT values
for the specified PROBE . Defaults are listed in the table on page
267. See the CBL 2/CBL and CBR guidebook for specific
MIN à MAX ranges. Enter values using the number keys.
UNITS
The results are displayed according to the UNITS specified. To
specify a unit measurement ( Temp or Sonic probes only),
highlight the one you want using the cursor keys, and then
press b.
DIRECTNS (Directions)
If DIRECTNS=On , the calculator displays step-by-step directions
on the screen, which help you set up and run the data
collection. To select
On or Off , highlight the one you want with
the cursor keys, and then press b.
With the Sonic data collection probe, if DIRECTNS=On , the
calculator displays a menu screen before starting the
application asking you to select
1:CBL or 2:CBR. This ensures
that you get the appropriate directions. Press 1 to specify CBL
or 2 to specify CBR .
Data Collection Comments and Results
To label a specific data point, press b to pause the data
collection. You see a
Comment= prompt. Enter up to a
six-character comment using the Text editor (- t) or
number keys. The calculator automatically converts the
comment labels and the corresponding results into list
elements using the following list names (you cannot rename
these lists):