Texas Instruments TI-73 EXPLORER - Manual (Page 203)

Chapter 10: Drawing
197
7310ENG.DOC Draw Texas Instruments Revised: 05/29/98 6:43 PM Printed: 05/19/99 9:01 AM Page 197 of 22
Text( Text( 2 7 7
You can access
Text(
from the Graph screen, Home screen, or
the Program editor.
Text(
allows you to draw text on the Graph
screen when a graph is displayed. Use the Text editor
(- t) to access all text characters. You may enter TIN73
functions, variables, and instructions as text. The font is
proportional, so the exact number of characters you can place
on the graph varies.
Text( from the Graph Screen
To draw text on the Graph screen:
1. From the Graph screen, select 2
7
. The cursor
appears in the middle of the Graph screen.
2. Place the cursor at the point where you want the text to
begin.
3. Press - t to display the Text editor. Select the text
characters. Highlight
Done
with the cursor, and then press
b. The selected text is pasted onto the Graph screen.
4. Repeat steps 2 and 3, as necessary. To cancel
Text(
, press
:.
From the Graph screen, Label Quadrant I with
QUAD1
.
1. Clear all previous drawings,
and select the beginning
point where you want the
text to start.
* 2
1
2
7
# $ " !
(as necessary)
2. Using the Text editor, enter
QUAD1
.
- t
Q
b
U
b
A
b
D
b
1 Done
b
³