Transmission error conditions – Texas Instruments TI-73 EXPLORER User Manual
Page 266
260
Chapter 13: Link and the CBL
àCBR Application
APPS.DOC Chapter 13: Link and CBL/CBR Application, English Julie Hewlett Revised: 02/07/01 10:34 AM
Printed: 02/07/01 10:35 AM Page 260 of 22
•
When you select
1:Rename
, the
Name=
prompt is displayed,
and you can enter another appropriate variable name
using the - } menu (for example, renaming
Pic1
to
Pic2
where
Pic2
is undefined), or you can enter text using
the Text editor (- t) (for example, renaming
L
1
to
¨
ABC
where
¨
ABC
is undefined). When renaming lists, do
not enter the
¨
(- v
OPS
9
). The calculator assumes
that it is a list name. Press b to resume transmission.
Note
: You cannot rename software applications or
constants (the
1:Rename
option is excluded from the
DuplicateName
menu).
•
When you select
2:Overwrite
, the sending unit’s data
overwrites the existing data stored on the receiving unit.
Transmission resumes.
•
When you select
3:Omit
, the sending unit does not send
the data in the duplicated variable name. Transmission
resumes with the next item.
•
When you select
4:Quit
, transmission stops, and the
receiving unit exits receive mode.
Transmission Error Conditions
A transmission error (
Error in Xmit
) occurs after one or two
seconds if:
•
The unit-to-unit cable is not attached to the sending or
receiving unit. Note: If the cable is attached, push it in
firmly and try again.
•
The receiving unit is not set to receive transmission.
•
You attempt a backup between a TI
N73 and a TIN82 or
TI
N83.
•
You attempt a data transfer from a TI
N73 to a TIN82 with
data other than numerical lists,
L
1
-
L
6
, or without using
menu item
9:Vars to TI82
.