Toshiba D-VR17KB - Manual (Page 34)

34 EN
• Cancel the timer-standby mode by pressing
[TIMER SET] before operation for either DVD or
VCR. When finished operating, press [TIMER SET]
to resume the timer-standby mode.
• In the timer-standby mode, you can turn on the
power and use the component (VCR or DVD) which
is not currently timer-programmed.
PDC (Programme Delivery Control)
The Programme Delivery Control (PDC) assures that
the TV programmes you have programmed for timer
recording are recorded exactly from beginning to end,
even if the actual broadcasting time differs from the
scheduled time due to a delayed start or extension of
the programme duration. Furthermore, if a
programme is interrupted, the recording will also be
interrupted automatically and resumed when the
programme starts again.
If the PDC signal drops out because the broadcast
signal is weak, or if a broadcasting station does not
transmit a regular PDC signal, the timer recording is
performed in normal mode (without PDC) even if it
was programmed for PDC. If the starting time of the
PDC timer recording is between 0:00 and 3:59 on a
given day, the PDC function will operate from 20:00
on the previous day to 4:00 on the next day. If the
starting time of the PDC timer recording is between
4:00 and 23:59 on a given day, the PDC function will
operate from 0:00 on the given day to 4:00 on the
next day. This means that if the relevant programme
is broadcasted within this period, it is recorded
correctly. If the timer is not programmed correctly, the
incorrect timer setting stays in effect unless you
cancel it. To cancel an incorrect timer setting, refer to
“Checking, Cancelling or Correcting the Timer
Programming Information” below.
Checking, Cancelling or Correcting
the Timer Programming Information
1 Press [TIMER SET] so that the
icon disappears from the front panel
display.
2 Press [TIMER PROG].
Timer Programming list will appear.
3
Check the information on the list you
want to edit.
4
A) To delete the timer programme:
1) Select the programme you want to delete using
[ U / D], then press [ENTER].
2) Select “Delete” using [ U / D], then press
[ENTER].
Confirmation window will appear.
3) Select “Yes” using [ U / D], then press
[ENTER].
B) To correct the timer programme:
1) Select the programme you want to correct
using [ U / D], then press [ENTER].
2) Select “Program Change” using [ U / D], then
press [ENTER].
3) Correct the timer programme by using
[ U / D / L / P], then press [ENTER].
5
Press [TIMER PROG] to exit.
6
Press [TIMER SET] to return to the
timer-standby mode.
To check the timer programming in process
Press [TIMER PROG].
Note
• If a timer recording is proceeding, that programme is
highlighted in red. In such a case, you cannot select
any other programmes.
• When you check the timer programming in progress
by pressing [TIMER PROG] during operations of the
component (DVD or VCR) which is not currently
used for the timer recording, the programme will not
be highlighted. In this case, you cannot select other
programmings.
To Stop the Timer Recording in
Progress
On the front panel of the unit, press
[ S (STOP)] to stop the disc recording or
[ O/S (STOP / EJECT)] to stop the tape
recording.
Note
• [STOP S] on the remote control is not effective.
E9GA0BD_EN.book Page 34 Monday, March 26, 2007 10:14 AM