Tripp Lite NetCommander B072-016-1 - Manual (Page 19)

19
Verifying the Server Interface Unit's version number
Before you can check a Server Interface Unit, you must uncheck the Switch Unit box options.
To verify the Server Interface Unit version number:
Open the KVM Switch Update program 1.
Check one or more or all of the Server Interface Units 2.
Click 3. . The firmware version number appears after the Server Interface Unit number
Click 4. . The hardware version number appears after the Server Interface Unit number
When “Not Responding” appears, no computer is connected, or it is switched off.
Using the update computer, open up the firmware upgrade software 2.
In the KVM Switch Update window, select the KVM switch, KVM switch OSD or SIU(s) you 3.
would like to upgrade
From the File menu, choose Open to open up the firmware upgrade file you downloaded from
4.
www.tripplite.com
Click the Start button to begin the update. When finished, the firmware version number will appear
5.
next to the unit you just updated
Check to make sure the firmware version number is correct by following the steps on page 20-21. If
6.
it does not show up as the most current firmware version number, start the upgrade over again
Figure 7.8 Open Window
7.8 Updating the Firmware
7.7 Obtaining New Firmware
Warning! Never switch off any computer connected to the KVM system during the Firmware
Upgrade process.
Download the latest firmware for your KVM switch from www.tripplite.com 1.
Download the latest firmware for your system from www.tripplite.com.
7. Software
(continued)
7.6 Verifying the Version Numbers (continued)