Tally Genicom T5023+ - Manual (Page 226)

Controlling the MSR / MICR functions Additional commands (Printer)
216 T5023/5023+ - Programming Guide
After the execution of the command a acknowledgement CSI n1; n2 # r is produced,
which can be evaluated in the
program. The acknowledgement contains the num-
ber of writing attempts and a message if an error has occured during control rea-
ding.
– In the MSR unit of the document printer, the characters are limited
to the range from 30h-3Fh. Characters outside this range lead to an
error in the printer control.
– The command triggers the output of characters still in the print buf-
fer to the document printing point.
i