Tally Genicom T5023+ User Manual
Page 154
Definition of characters
Character set commands
144
T5023/5023+ - Programming Guide
Example of the definition of LQ characters:
The example shows the following steps:
–
Definition of two proportional LQ characters under the character codes of the
letters A and B; the character width of the first character amounts to ten dot
columns, that of the second character eighteen dot columns.
–
Printing of the newly defined characters in normal and elongated print.
Result:
BEGIN
PRINT(char(27),"p",char(1))
New definition A
PRINT(char(27),"&",char(1),"AB")
<-- and B (proport.)
PRINT(char(3,10,1))
<-- Different
PRINT(table 1)
character
PRINT(char(3,18,1))
<-- widths
PRINT(table 2)
PRINTLF("ABABABCDEFG")
PRINT(char(27),"%",char(1))
PRINTLF("ABABABCDEFG")
<-- C to G not newly
PRINT(char(14))
defined
PRINTLF("ABABABCDEFG")
END
BEGIN table 1
char(0,8,0,0,4,0,0,8,0,0,4,0)
char(0,132,64,0,72,128,0,165,64)
char(0,90,128,0,37,0,0,26,0)
END Table 1
BEGIN table 2
char(0,8,0,0,4,0,0,8,0,0,4,0)
char(0,8,0,0,4,0,0,8,0,0,4,0)
char(0,8,0,0,4,0,0,8,0,0,4,0)
char(0,132,64,0,72,128,0,165,64)
char(0,90,128,0,37,0,0,26,0)
END table 2