Tally Genicom T5023+ - Manual (Page 102)

Print quality and character size Standard commands
92 T5023/5023+ - Programming Guide
Print quality and character size
This section describes the commands for setting the print quality and the character
size.
Command Function
ESC x (n) Switching over the print quality (Draft/ LQ)
J
ESC k (n) Selecting the LQ type font
J
ESC p (n) Switching proportional spacing on/ off
J
ESC P Selecting the character size 10 cpi
J
ESC M Selecting the character size 12 cpi
J
ESC g Selecting the character size 15 cpi (mikro print)
J
Notes on the print quality:
According to the application one of the two following print quality set-
tings can be selected:
– Dr aft print quality
This print quality is especially suited for quick draft printing. The
characters are printed with a (horizontal) density of 60 print dots per
inch.
– LQ print quality (Letter Quality)
The LQ print quality is suited for printing the (corrected) final versi-
on of a document. The characters are printed with a (horizontal)
density of 180 print dots per inch.
In comparison to the draft print quality the characters contain more
print dots. From this on the one hand a neater print face results, on
the other hand a lower print rate compared with draft printing. In LQ
print quality the type fonts “Roman” and “Sans Serif” are available
standardly for the optical arrangement of a document. Further type
fonts can be used if the appropriate font is loaded
.
Notes on the character size:
– After switching on or initializing the printer the characters are prin-
ted with the data set in the emulation menu.
In normal print all the characters of one character size have the
same spacing (for example 1/10 inch with 10 cpi).
i
i