Toshiba B-SX600 SERIES - Manual (Page 96)

12. TROUBLESHOOTING
12- 10
Error messages Possible causes Solutions
Ribbon error
Reset ribbon.
The ribbon has torn apart. • Reload a ribbon.
⇒
4. LOADING THE RIBBON
• If the ribbon has been heated by the Print
Head and torn apart, decrease the print
tone.
⇒
[Help] on the Printing Preferences
page in the Printer Driver Properties
Ribbon error
Reset head unit. The rotation of the ribbon
shaft has not been
detected. Open the Side Cover. Place the Upper Unit
in a right position.
⇒
4. LOADING THE RIBBON
5.1 How to Load the Media
Peeling failed Peeling has failed. • If the loaded media is jammed in the Front
Cover section, clear it.
⇒
10.2 Removing Jammed Media from
the Peel-off Unit
• Replace the Rubber Roller in the Peel-off
Unit if it has worn out.
⇒
1.5.2 Precaution when using the
Peel-off Unit
• Select and use an appropriate size of the
media.
⇒
3. MEDIA AND RIBBON
• Check the printer driver settings.
⇒
[Help] on the Printing Preferences
page in the Printer Driver Properties
• The media size is specified correctly.
• The print area is specified correctly.
⇒
1.5.2 Precaution when using the
Peel-off Unit
Cut failed The media has not been cut
correctly. • Remove jammed media from the way of the
Cutter Carriage.
⇒
10.1 Removing Jammed Media from
the Cutter Unit
• Select and use an appropriate size of the
media.
⇒
3. MEDIA AND RIBBON
• Check the printer driver settings.
⇒
[Help] on the Printing Preferences
page in the Printer Driver Properties
• The media size is specified correctly.
⇒
1.4.2 Precautions when using the
Cutter Unit
• The cutting edge of the Cutter is not sharp.
⇒
1.4.2 Precautions when using the
Cutter Unit