Toshiba B-SX600 SERIES - Manual (Page 17)

1. PRODUCT OVERVIEW
1- 10
1.4.2 Precautions when using the Cutter Unit
The following precautions must be taken when the Cutter Unit is used.
The thickness of the media that
can be cut is between 0.08 mm
and 0.26 mm. Do not cut any
media that falls outside this
range, as this may cause a
printer failure.
When using a label stock, be
sure to cut the gaps. Cutting
labels will cause the glue to stick
to the cutter, which may affect the
cutter quality and shorten the
cutter life.
Do not cut any materials other than
paper (e.g. fabrics and films), as this
may cause a printer failure.
The cutter is a consumable. The
cutting edge wears out from an
extended period of use, causing the
cutter to be blunt. When replacing the
cutter, please contact your nearest
authorised TOSHIBA TEC
representative for assistance.
When the perforated media is used, do
not cut
± 1 mm around the perforation,
as this may cause a paper jam in the
Cutter Unit.
Cut position
Label
Backing
paper
A
rea where cutting is
not allowed
Perforation