Toshiba B-SX600 SERIES - Manual (Page 102)

13. FREQUENTLY ASKED QUESTIONS (FAQ)
13- 5
Q: Are there any limitations on a print or feed speed in Strip mode?
A:
When the model with the Peel-off Unit is used, a print speed needs to be reduced to 4 ips or less to
ensure the steady peel-off operation. (In the printer driver, a feed speed is set to the same value as a
print speed.)
A print speed needs to be further reduced to 2 or 3 ips depending on the type or size of the media.
Check the peel-off operation first, then adjust a print speed if necessary.
Q: Is there any difference in acceptable media and ribbons between the standard model and the
model with the Peel-off Unit?
A:
There is no difference between the standard model and the model with the Peel-off Unit in the material
of the acceptable media and ribbons. However, when performing peel-off operation, the size of the
available media is different.
Standard model Model with Peel-off Unit Remarks
Max. backing paper
width
120 mm
Min. label length 5 mm 12 mm
Min. media width 15 mm 10 mm
Fanfold paper
Perforation
Allowed Not allowed
Media may be torn off
from perforation.
Min. label thickness 0.05 mm 0.05 mm
Max. thickness of
backing paper
0.1 mm 0.1 mm
Glassine paper
Roll direction Inside/outside Inside
In addition to the above specifications, be careful of the following points when using the model with the
Peel-off Unit.
The acceptable media length for the Peel-off Unit is the same as that of the standard model.
However, when using a long label, prevent a peeled one from sticking to the table on which the
printer is placed.
Do not use a media roll with seams. Use a label stock with seamless backing paper.
Neither fabrics nor special labels are usable. Also, using non-rectangular labels is not allowed.