Lamp replacement – Toshiba TLP560 User Manual
Page 65
65
Maintenance
Lamp replacement
The lamp will eventually begin to project dark
or dull pictures and finally will not light up.
(Lamp’s life depends on operating
conditions.) In such a case, replace the lamp
with new one.
CAUTION
• If you use the projector mounted on the ceiling,
ask the dealer to carry out the maintenance
such as cleaning or replacement of the lamp.
• When replacing, always use lamp “TLPL55”
(sold separately). For details, refer to the lamp
instruction.
• If you have been using the projector, the lamp
will be very hot, and may cause burn injuries.
Wait for the lamp to cool (for longer than 1
hour) before replacing it.
• If the lamp should break, please handle with
care to avoid injury due to broken pieces and
contact your dealer for repair service.
Unplug the power cord.
1
Wait until the lamp gets cool enough.
2
3
Take off the lamp cover on the
bottom panel.
Loosen the two screws, and pull off the
lamp cover.
Pull out the lamp.
Loosen the two fixing screws, and lift up the
handle to pull out the lamp.
4
2
3
1
Continued
Lamp cover
2
3
1