Toshiba GA-1190 - Manual (Page 97)

Setting up Network Settings (Printing Function) 95
Setting up the SNMP network service
In SNMP Network Service, you can enable or disable the SNMP to monitor the device status
using a network monitoring utility. If an administrator wants to monitor the device status with a
monitoring utility, programmed to fit the MIB, you must enable the SNMP and SNMP Traps.
1) Enable SNMP
Select whether the SNMP monitoring with MIB is enabled or disabled. This must be enabled
to allow users to connect using the AddressBook Viewer.
2) Read Community
Enter the trap community name for the SNMP Traps.
If you specify a community name other than “public” for the Read Community, the applica-
tions that use MIB (AddressBook Viewer) will be unavailable. The SNMP communication of
the printer driver also will be unavailable, so that the obtaining the configurations and con-
firming the department code will be disabled.
3) Read Write Community
Enter the Read Write community name for the SNMP Traps.
If you specify a community name other than “private” for the Read Write Community, the
applications that use MIB (AddressBook Viewer) will be unavailable. The SNMP communi-
cation of the printer driver also will be unavailable, so that the obtaining the configurations of
this equipment and confirming the department code will be disabled.
4) Enable Authentication Trap
Select whether sending a SNMP Traps when this equipment is accessed using SNMP from
a different read community.
1
2
3
4
5
6
7
8