Trango Broadband Access5830 User Manual
Page 63
Management
Trango Broadband Wireless — Access5830 User Manual Rev. F
page 59
Command Description
AP/S
U Remarks
group 0: disabled group
sudb view
display all entries in SUDB
AP
sulog
display last SU log
1. Time tag (ms)
2. Sample period (1..60 mins)
3. RF receives user payload in
Kbytes
4. RF transmits user payload
in Kbytes
5. Local Ethernet receives
user payload in Kbytes
6. Local Ethernet transmits
user payload in Kbytes
7. RSSI
8. TX
power
8. Temp
AP
default sample period = 10 mins
sulog <# of entry, 1..18>
display SU log entry (#)
AP
up to 18 entries (3 hours)
sulog lastmins [
If time stamp = current up time
stamp, then will display last SU log.
Otherwise will display:
[#Begin]
[#None]
[#End]
AP
sulog sampleperiod [<1..60>]
set or display SU log sample period
AP
default sample period = 10 mins
survey
spectrum analysis pf the entire band
Both
Example: survey ism 30 h
sw
display current switch settings
Both
sw 0 [
packet filter for broadcast/multicast
On = filtering
Both default
=
on
need to update flash
sw 1 [
enable SU to autoscan searching
each channel in scan table for AP
On = Autoscan enabled
SU default
=
on
need to update flash
sw 2 [
TCP/IP service for AP. Allows
TCP/IP access to SU from AP side
of network via wireless link.
SU default
=
off
need to update flash
sw 3 [
enable SU to SU feature (peer-to-
peer)
AP default
=
off
need to update flash
sw 4 [
broadcast time stamp to SU (AP
only)
AP default
=
off
need to update flash
sw 5 [
HTTPD browser interface enable /
disable. On = enabled
Both default
=
on
need to update flash
sw 6 [
TCP/IP Access to Ethnernet port of
SU while radio is in Opmode SU
SU default
=
on
need to update flash
sysinfo
display system configuration
Both
temp
display current temperature Both
Note:
FOX series SU does not
include an internal temperature
sensor. FOX series radio
receives its temperature from the
AP, as long as AP is running
current firmware. If AP is
running older firmware, FOX
Series SU will report
temperature of 35
° C.