Trango Broadband Access5830 - Manual (Page 59)

Management
Trango Broadband Wireless — Access5830 User Manual Rev. F page 55
Command Description
AP/S
U Remarks
ipconfig
+ assign radio’s IP, subnet mask, and
gateway IP Both
linktest [
[<# of packets> [<# of cycles>]]] perform over-the-air test for packet
loss and throughput AP
log display last log entry:
1. Time tag (sec)
2. RF receives user payload in
Kbytes
3. RF transmits user payload
in Kbytes
4. Local Ethernet receives
user payload in Kbytes
5. Local Ethernet transmits
user payload in Kbytes
6. RSSI (SU only)
7. TX power (SU only)
8. Temp
Both one log entry every min
log <# of entry, 1..179> display last log entries Both up to 3 hours
log sum <# of entry, 1..179> display the sum of last log entries
1. RF receives user payload in
Kbytes
2. RF transmits user payload
in Kbytes
3. Local Ethernet receives
user payload in Kbytes
4. Local Ethernet transmits
user payload in Kbytes
5. RSSI of latest log entry (SU
only)
6. TX power of latest log
entry (SU only)
7. Temp of latest log entry
Both up to 3 hours
logout logout of CLI session Both
maclist [] display or resets MAC table Both
opmode display current Opmode Both
opmode ap [] set Opmode to be AP (use “y” if
Opmode is not same as default) AP
opmode su [] set Opmode to be SU (use “y” if
Opmode is not same as default) SU
ping ping local Ethernet device Both It only works for local Ethernet
devices, not SU or any device
behind SU.
power display default and current TX
power level Both default = max
power specify TX power for both bands Both SUs’ power will be adjusted by
AP when associated
reboot reboot unit Both
remarks [] string length should be 1 to 28
characters Both