Trango Broadband Access5830 User Manual
Page 61
Management
Trango Broadband Wireless — Access5830 User Manual Rev. F
page 57
Command Description
AP/S
U Remarks
255.255.255.255, radio will not
ping gateway.
set httpport [
set or display HTTPD port number
Both
default = 80
set mir
enable or disable MIR threshold
AP
default = off
set mir threshold [
set MIR threshold,
1000..9999
AP
default = 6114 kbps (6 Mbps)
set rssitarget
set Target RSSI to be received from
SUs
AP
It must be in the range -45 to -75
and +5 dB higher than RF RX
Threshold.
set serviceradius [
set or display service range,
= 0 .. 30
AP
default: ISM = 10 miles
UNII = 4 miles
Used for determining timeout
duration in polling sequence.
Does not actually determine
service range.
set snmpcomm [
display or assign SNMP community
string
AP
Community string is SNMP’s
password.
set suid
specify unit’s SU ID
SU
After changing SU ID it is
recommended to reboot the
radio.
set telnetport [
specify telnet port,
1..65534
Both default
=
23
ssrssi
display RSSI on the current channel
Both
Useful for antenna alignment.
To stop the continuous readout
hit space, enter.
su
display the SU info summary
AP
su
display SU payload status
AP
su all
display all registered SU
AP
su info
display request SU’s info:
1. H/W
version
2. F/W
date
code
3. FPGA
version
4. Image
checksum
5. Device
ID
6. IP
address
7. Scan sequence table
8. Packet
filter
on/off
9. Auto scan AP on/off
10. TCPIP for AP on/off
11. HTTPD on/off
12. Remarks
AP
su ipconfig
assign radio’s IP, subnet mask, and
gateway IP
AP
su live
display all SUs that are associated
AP
su password
set SU’s password remotely
AP
su ping
request SU’s ranging and RSSI
information
AP
su powerleveling
calibrate SU’s power leveling
AP
Target RSSI in dB
su poweroff
display all SU that are in the
“poweroff” group
AP
su priority
display all SUs that are in the
priority group
AP