Toshiba P100/P105 - Manual (Page 69)

69 Getting Started
Using external display devices
5.375 x 8.375 ver 2.3
3 Turn on the external device.
4 Set the display mode by pressing Fn + F5 , or by
configuring the Display Properties settings.
Directing the display output when you turn on the computer
Once you have connected an external display device, you can
choose to use the internal display only, the external device
only, or both simultaneously. The quickest way to change the
display output settings is to use the display hot key (
Fn + F5 ):
1 Press Fn and F5 simultaneously.
2 While holding down Fn , press F5 repeatedly until the
setting you want takes effect. Briefly pause each time you
press the
F5 key to allow time for the display to change.
This hot key cycles through the settings in the following
order:
❖ Built-in display only
❖ Built-in display and external monitor simultaneously
❖ External monitor only
❖ TV
❖ TV and built-in display
❖ DVI appears if you have a projector or a monitor
connected to the DVI video port (DVI is available on
some models)