Setting the brightness of the backlight (dimmer), Restoring default settings (initialize), Formatting the sd card – Tascam DR-100 User Manual

Page 44: Setting the main battery source (main), See “setting, Installed. (see “setting the main battery source, 10–settings and information

TASCAM DR-100

Setting the brightness of the

backlight (DIMMER)

You can set the brightness of the backlight.

1 Press the

key to open the

screen.

2 Use the wheel to select

SETUP

, and press the

ENTER/MARK

key

3 Use the

DIMMER

item to set the value.

Values: OFF, LOW, HIGH (default)

Restoring default settings

(INITIALIZE)

You can restore the various settings of this device

to their factory defaults.

1 Press the

key to open the

screen.

2 Use the wheel to select

SETUP

, and press the

ENTER/MARK

key

3 Press the ≤ key at the

INITIALIZE

item, and

then press the

ENTER/MARK

key to open a confir-

mation screen.

4 Press the

ENTER/MARK

key again to initialize the

unit or press the

STOP

key to cancel.

Formatting the SD card

There are two ways to format the SD card in this

unit: Quick Format and Full Format.
Formatting an SD card erases all audio files on

the card and automatically creates new “MUSIC”

and “UTILITY” folders as well as the “dr-1.sys”

file.

1 Press the

key to open the

screen.

2 Use the wheel to select

SETUP

, and press the

ENTER/MARK

key

3 Press the

≤

key at the

QUICK FORMAT

FULL

FORMAT

item, and then press the

ENTER/MARK

key

to open a confirmation screen.

QUICK FORMAT

screen

FULL FORMAT

screen

4 Press the

ENTER/MARK

key to initialize the unit

or press the

STOP

key to cancel.

NOTE

Use a PS-P520 AC adapter (sold separately) or be

certain that the unit has plenty of remaining battery

power when formatting. Full Format checks for

memory errors, so it takes a particularly long time

compared to Quick Format.

Setting the main battery source

(MAIN)

When both the lithium ion battery and AA

batteries are installed, you can set one as a main

power source and the other as a backup. Usually

the unit uses the main power source.
When the remaining power of the main battery

source becomes low, the unit automatically

switches to the backup, allowing continued

operation.
The battery source currently used and the amount

of remaining power it has are shown at the upper
right of the Home Screen.

1 Press the

key to open the

screen.

2 Use the wheel to select

BATTERY

, and press the

ENTER/MARK

key

3 Use the

MAIN

item to set the main battery power

source.

10–Settings and Information