Tascam DR-100 - Manual (Page 36)

36
TASCAM DR-100
Loop playback (I/O LOOP)
You can set an IN point (starting point) and OUT
point (ending point) within a file and play the part
of the file between these points repeatedly.
1 When the Home Screen is open and the track is
playing or paused, press the I/O LOOP key at the
position where you want the loop to start to set
the IN point.
2 When the track is playing or paused, press the
I/O LOOP key at the position where you want the
loop to end to set the OUT point.
3 After setting both the IN and OUT points, loop
playback starts automatically.
4 Press the STOP ( ª ) key to stop loop playback.
You can also press the PLAY/PAUSE ( ¥/π ) key to
restart playback from the endpoint.
NOTE
You cannot set the IN and OUT points in different •
files.
IN and OUT point settings are lost when you select
•
a different file.
If you press the I/O LOOP key when IN and OUT
•
points are already set, their settings will be erased.
Setting accurate IN and OUT points might not be
•
possible with Variable Bit Rate (VBR) format MP3
files.
Adjusting the playback speed (PB
CONTROL)
You can adjust the playback speed by up to -50%
or +16% of the original value. When doing so, it
is possible to change the pitch with the speed or
maintain the original pitch.
1 When the Home Screen is open, press and hold
the PB CONTROL key to open the
PB CONTROL
screen.
2 Set the
VSA
item to
ON
or
OFF
. When Variable
Speed Audition (VSA) is
ON
, pitch does not
change even when the speed is changed. When
OFF
, the pitch changes with the speed.
3 Use the
SPEED
item to adjust the playback speed.
4 Press the HOME key to return to the Home
Screen.
5 Press the PB CONTROL key briefly to turn this
function ON and OFF.
NOTE
You can also turn PB CONTROL ON and OFF from the
PB CONTROL screen.
Adjusting the playback volume
The volume output from the built-in speaker or
the connector can be adjusted by using the
/SP
OUTPUT
dial.
7–Playback