Toshiba Tosvert RS485 - Manual (Page 38)

E6581315
37
6.1. Proportional control of speed
Proportional control of frequency can be performed in two ways: control by selecting frequency
points and control by adjusting the ratio to the maximum frequency. This section explains propor-
tional control of inverters by means of a master inverter (inter-drive communication), although the
AS1 series inverters are ready for proportional control by means of the “S” command even when
they are operated under the control of a computer (computer-linked communication) (in the latter
cases, read the master inverter as the computer).
Proportional control can also be performed in units of Hz using ordinary write commands (W and P
commands) (frequency point selection only). For proportional control in units of %, however, the S
command should be used.
* For proportional control by selecting frequency points, the gradient can be set variously according
to the way each inverter is used. For proportional control by controlling the ratio to the maximum
frequency, settings can be made easily without consideration of the rate at which the frequency is
increased or decreased to the target frequency.
• Data sent by the master inverter to slave inverters in inter-drive communication mode (frequency
command value)
FH side Master
fc side Master
(%) fc
10000 ×
＝ (1=0.01%)
* Fractions under 1 (0.01%) are omitted. Therefore, an error of 0.01% is introduced at the maxi-
mum.
• Conversion of the frequency command received by a slave inverter (when the “frequency point
selection” option is not selected)
The value obtained by the following conversion calculation is written in RAM as a frequency com-
mand value.
10000
FH side Slave (%) data receive Slave
) Hz ( fc
×
= (1=0.01Hz)
* Fractions under 1 (0.01Hz) are omitted. Therefore, an error of 0.01Hz is introduced at the maxi-
mum.
[Diagram of speed proportional control]
Point conversion
fc
fc fc
1 oint －Point1）＋P
Point1 Point2
2 Point
command＝ Slave command Master (
int Po
×
−
− 1
FH Slave
10000
data receive Slave
＝ Hz Data × ) ( 0 1000
FH Master
Master
data＝ send Master ×
fc
000 10
FH Slave
Data＝ ×
fc
Setting 2 fc (

)
Slave command
Point2
( )
Point1
(

)
Master command
Setting 1 fc (  )
(Hz)
Hz
(%)
%
Operation performed by the
master (or use of S command) Operation performed by the slave
%
%
Hz
Point selection ()
Fc (Hz)
Points not selected
Points selected
* fc=frequency reference, FH=maximum frequency
Hz