Tascam SS-R1 - Manual (Page 15)

TASCAM SS-R1/SS-CDR1 RS-232C Protocol Specification
14
TEAC Corporation
AUTO CUE SELECT
Specifies the auto cue mode setting of the controlled device.
A return command is returned only if Sense [FF] is specified.
The AUTO CUE LEVEL setting is made by the command "AUTO CUE LEVEL PRESET [20]."
Command 30
Machine ID
0
Data 2 bytes
Data 1 Data 2 Description Remarks
0 0 Auto Cue Off
0 1 Auto Cue On
F F Sense Requests that the preset content be returned.
・ If data other than the above is received, the SS-R1/SS-CDR1 will transmit ILLEGAL [F2].
Return AUTO CUE SELECT RETURN [B0]
AUTO TRACK SELECT
Specifies the auto track mode of the controlled device.
A return command is returned only if Sense [FF] is specified.
Command 31
Machine ID
0
Data 2 bytes
Data 1 Data 2 Description Remarks
0 0 Auto Track Off
0 1 Auto Track On
(Level)
Executes auto track according to the specified AUTO
TRACK LEVEL.
0 2 Auto Track On
(Digital
Direct)
Executes auto track according to the track data within the
S/P DIF signal.
0 3 Auto Track On
(Time)
Executes auto track according to the specified AUTO
TRACK TIME.
F F Sense Requests that the preset content be returned.
・ If data other than the above is received, the SS-R1/SS-CDR1 will transmit ILLEGAL [F2].
Return AUTO TRACK RETURN [B1]
EOM TRACK TIME PRESET
Specifies the time (in seconds) at which the EOM (End Of Message) will give notice that the end of
track is approaching.
The range is 1 to 99 seconds, or OFF.
A return command is returned only if data [FF] is specified.
Command 32
Machine ID
0
Data 2 bytes
Data 1 Data 2 Description Remarks
0 0 EOM Track
Off
N1 N2 Number of
seconds
N1：Tens digit of seconds, N2： Ones digit of seconds
F F Sense Requests that the preset content be returned.
・ If data outside the range specified above is received, the controlled device will transmit
ILLEGAL[F2].
Return EOM TRACK TIME RETURN [B2]