Toshiba D-R1SU - Manual (Page 129)

129
Recording
Playback
Editing
Library
Function setup
Others
Introduction
DVD Recorder Operation
AV Record Quality
DVD-RAM DVD-RW DVD-R
You can select from 5 combined picture and sound
quality recording settings prior to actual recording.
Actual selection applied becomes the default setting for
the normal recording or programmed recording.
e.g.
• To make a combination of picture and sound
quality settings.
1) Press the / / / buttons to select the
desired item (“Mode”, “Rate”, or “Audio Quality”).
2) Press the ADJUST button to change the setting
of each item.
• To apply the combination of picture and sound
quality settings.
1) Press the ADJUST button to change the
setting.
You can confirm the available recording time for
the selected setting on the bottom screen.
2) Press the ENTER button.
Notes
• You can change the combination of picture and sound
quality settings also by displaying the Quick Menu on a
LIBRARY MENU or during stop mode, then selecting “AV
Record Quality”. Either of the above methods updates the
setting of this recorder.
• If you set “SP” or “LP”, you cannot select “L-PCM”.
• Depending on the sound quality settings, the upper limit for
the picture quality setting differs.
• You can adjust the manual rate for picture quality by
0.2 Mbps from 2.0 to 9.2. (You cannot set the rate from 1.4
to 2.0.)
Picture Record Mode
DVD-RAM DVD-RW DVD-R
Adjusts problems with the brightness of video signals of
TV broadcasts or other external input.
(Only use this setting when you cannot adjust the
brightness satisfactorily with the Custom Picture Setting in
the Picture/Audio Settings (
Page 125) of this
recorder.)
Important:
• This setting changes the video signal to record and the
recorded signal is not returned to the original state even
when this setting is changed after recording. When
duplicating from VHS tape, if you can check the video
recording state beforehand, we recommend first playing
back for a while and checking the overall brightness
tendency, then setting an appropriate mode.
Standard:
The brightness of signals received with this recorder
and external input signals is adjusted automatically.
This is normally the setting to use.
Mode 1:
This setting is used to record the signals darker when
the screen is too bright.
Mode 2, 3, 4:
As the number rises, the signals are recorded brighter.
Use these modes to adjust the brightness.
Audio Input Level
DVD-RAM DVD-RW DVD-R
Sets the audio input level of recorded sound.
Press the / buttons to select the desired item, and
then press the / buttons to adjust the input level.
TV/CATV (L):
Sets the input level for the left channel.
(R):
Sets the input level for the right channel.
Line1, 2, 3 (L):
Sets the input level for the left channel of the external
input connectors.
(R):
Sets the input level for the right channel of the external
input connectors.
AV Record Quality
Custom Setting
5
4
3
2
1
D /M1
D /M1
D /M2
D /M1
L-PCM Manual
Manual
Manual
S P
L P
6. 6
4. 6
2. 2
6. 0
3. 2
Mode Setting Rate Audio Quality
Total Recording Time: approx. 122min.
(with 4.7 GB unused)
D /M1 SP DVD
- - - 4.6