TechniSat DIGITY CI Operating Manual - Manual (Page 45)

Power supply:
Mains power adapter:
Power requirement:
< 22 W
(in operation, horizontal
polarisation/ 400 mA LNB power)
< 12 W (in operation, excl. LNB)
< 10 W (Stand-by Mode)
Mains voltage:
180 V.... 250 V / 47...63 Hz AC
General:
Ambient temperature
+15°C...+35°C
Humidity < 80%
Dimensions (WxDxH): 305 mm x 135 mm x 65 mm
Weight: 0,8 kg
11 Trouble-shooting guide
Dear customer ,
we would like to point out once again that, if you experience
the following problem, you should first follow our suggested
solution before contacting the repair service.
The unit does not function properly (controls do
not respond, image frozen ...)
>
Disconnect the mains power supply for approx. 5
seconds, then connect it again.
> Then switch the receiver on again.
If the problem persists, you should then contact your repair
service.
45
?
Your appliance carries the CE mark, and complies with all relevant EU
standards.
Subject to alteration without notice. Not responsible for printing errors. Correct
at 10/02
Copying and reproduction only with specific permission of the publisher.
TechniSat and DIGITY CI are registerd trade marks of
TechniSat Digital GmbH
P.O. Box 560
D-54541 Daun
Germany
www. technisat.de
bed_anl_DIGITY CI_Quark3_en.qxd 31.01.03 16:47 Seite 45