TechniSat DIGITY CI Operating Manual - Manual (Page 37)

37
> When you have entered the settings for the test
transponder, press the Back key to return to the menu
related to motor antenna settings. The field for
entering the orbital position is active.
> Use the numeric keys to enter the orbital position of
the satellite and confirm by pressing
OK.
> Press the
OK-key to indicate whether you are
entering a westerly ( W) or an easterly (E) orbital
position.
In the position
Geo-positioning on (Point 8.2) you can
now press Rotate to Sat (Point 8.4.1) to rotate the antenna
dish to the programmed user satellite position.
In the position
Geo-positioning off you will have to rotate
the antenna manually (Point 8.3.2.2) to the required satellite
position.
8.3.2 Adjusting the satellite antenna
To adjust the antenna correctly for the satellite selected, resp.
to determine whether you can receive signals from the
satellite selected at the position you have set, a test
transponder setting is provided for each satellite.
The indication of signal strength and quality by this test
transponder allows you to align the antenna precisely.
8.3.2.1 Test-Transponder/LNB-configuration
To change the data relating to the respective test
transponder, proceed as follows:
>
Use the arrow keys to select the entry Current
satellite list.
> Press the OK key to open the satellite list.> Use the
arrow keys up/down to select the satellite position
on which you wish to change data.
> Confirm by pressing OK.
> Now, use the arrow keys to select the field LNB
config. and press the OK key to confirm.
The menu LNB Settings will be displayed
(Fig 8-12)
> In this menu, proceed as described in Point 5.4.3 ,
and enter the data of the test transponder and of the
LNB being used.
> Press the Back key to return to the setting for the
motor-driven antenna.
8.3.2.2 Antenna manual adjustment
You can achieve the optimum positioning of the antenna by
referring to the signal strength and signal quality indicators
displayed. Adjust the antenna so that both bar graphs show
the maximum values..
>
Use the arrow keys up/down to mark the field Save.
(Fig. 8-12)
bed_anl_DIGITY CI_Quark3_en.qxd 31.01.03 16:47 Seite 37