TechniSat DIGITY CI Operating Manual - Manual (Page 19)

6.6 Switching between TV and Radio
The pre-programming feature includes television programmes
as well as radio programmes. If the latter are selected, the
TV image is switched off, and the screen displays only the
programme name.
>
Use the TV/Radio key to switch the receiver into
radio mode. The receiver will go to the last radio
programme selected.
> Pressing the TV/Radio key again will return you to
the television programme last viewed.
6.7 Return to previous programme
> Press the Back key on the remote control to return to
the previously selected programme.
> Press the key again to revert to the programme
viewed before the switch.
6.8 Display clock and programme information
This function allows you to display programme information
related to the programme currently selected.
>
Press the blue function key to display information for
the programme currently selected.
On the lower half of the screen you will see a display showing
the current time, the name of the current programme,
including the start and end times of the programme, where
these are broadcast by the provider.
>
Where the information is available from the provider,
pressing the blue function key again will display
information relating to the following programme.
6.9 Additional programme information
Where broadcast by the provider, you can obtain additional
programme information by pressing the function
Programme info.
>
Press the yellow function key to open an additional
information window.
This will again display information relating to the
current programme.
> Press the yellow function key again to display
information on the following programme.
> Press the yellow key again to remove the information
window display and return to normal operation.
19
bed_anl_DIGITY CI_Quark3_en.qxd 31.01.03 16:47 Seite 19