TechniSat DIGITY CI Operating Manual - Manual (Page 39)

> Press
OK.
> Use the arrow keys up/down to select the desired
position.
> Confirm by pressing
OK.
The dish will now be rotated to the selected position.
The rotating procedure is indicated by a blinking
display “Rotating” in the menu.
8.4.1 Selecting a satellite position
To rotate the antenna to the position indicated in the satellite
list, your receiver is equipped with the function
Rotate to
sat..
>
Press the yellow function key (Actions) to open the
window listing the available actions.
> Use the arrow keys up/down to mark the item
Rotate to sat.
> Confirm by pressing OK.
> Press the green function key (Rotate to sat.) to rotate
the antenna to the selected position.
8.5 Deleting a satellite position
To delete a satellite position from the satellite list, proceed as
follows:
>
Use the arrow keys to mark the item Current
satellite list.
> Press
OK to display the current satellite list.
> Use the arrow keys up/down to select the satellite
you wish to delete.
> Confirm by pressing
OK.
> Use the arrow keys to mark the item Delete sat..
> To delete the selected satellite, press OK, a
confirmatory message will be displayed, then press
OK again.
8.6 Reference position
When installing the external installation, the motor must be
parked in the reference position (
0°). For this purpose you
can use the function “Go to reference position” at any time
to rotate to this position (
0°).
> Press the red function key (Ref.pos) to rotate the
antenna automatically to the reference position.
39
bed_anl_DIGITY CI_Quark3_en.qxd 31.01.03 16:47 Seite 39