TechniSat S1 - Manual (Page 76)

76
Problem Possible cause Solution
Current time not displayed while in
standby mode Current time not downloaded Switch to major programme, e.g.
ZDF, for approx. 30 seconds.
Unit cannot be switched on, or can-
not be operated Unit blocked Perform flash reset: Note! All perso-
nal settings are lost in this process.
>
Disconnect mains power plug.
> Press Standby and Programme
Up keys on unit simulta-
neously, and keep them
pressed down.
> While Programme Up and
Standby keys are still pressed,
reconnect mains power plug.
> Keep keys pressed down for
approx. 5 secs. until Display
“FLAS” appears
Recording on hard drive no longer
possible Hard drive is full Delete existing recording(s)
Deleting hard drive recordings not
possible File system of hard drive is dama-
ged Check hard drive (Point 7.15.3.3)
Bed_anl_.qxd 20.02.04 16:30 Seite 76