TechniSat S1 - Manual (Page 22)

7.2 Programme selection
7.2.1 Using the programme up/down keys
> Use the
programme up/down keys either on the
unit or on the remote control to move up or down by
one programme slot at a time.
7.2.2 Using the numeric keys
> Use the
numeric keys to enter the desired program-
me number.
For example:
1
for programme slot 1
1, then 4
for programme slot 14
2, then 3, then 4 for programme slot 234
When entering programme numbers of more than one digit,
you have approx. 3 seconds time after pressing a key to com-
plete the entry.
If you wish to enter a number consisting of only one or two
digits, you can speed up the switching procedure by holding
down the key a little longer on the last digit.
7.2.3 Using the Navigator (Programme list)
> Press
OK.
The programme list navigator will be displayed. In TV
mode, only TV programmes will be shown, while only
radio programmes will be shown while in Radio mode.
The currently selected programme will be highlighted.
(Fig. 7-1)
> Now, use the
up/down arrow keys to mark the
selected programme.
> Press
OK to switch reception to the desired program-
me.
> Use the
up/down arrow keys to move around the
list one programme slot at a time.
> Use the
left/right arrow keys to move around the
list one page at a time.
7.2.3.1 Selecting a list
To facilitate the finding of programmes, your receiver is equip-
ped with several programme lists. You have the choice of
selecting your
Favourites list (see Point 8.1), or you can
use the alphabetically sorted
Total list, or you can view a list
sorted by
Providers.
> Press
OK. The active programme list will be display-
ed.
> Now use the
red function key Category to open a
window displaying the programme list types
(Favourites list, Providers list and Total list).
The active type of programme list will be highlighted.
22
(Fig. 6-9)
A B
Position
Output
A B
Position
Output
A B
Option
Output
Example:
Bed_anl_.qxd 20.02.04 16:28 Seite 22