Tascam DP-01FX/CD - Manual (Page 63)

DP-01FX Appendix
TASCAM DP-01 Owner’s Manual
63
T
unin
g
a guit
a
r
The line of symbols on either side of the center square gets shorter as
the played note approaches the “target” and the center square fills
when the string is in tune:
Changing the tuning Most instruments are tuned to A=440Hz. If you
are playing with another instrument that cannot be tuned, you may
want to change this value, that is, tune your guitar to the other instru-
ment.
Use the jog wheel to change the reference tuning away from 440Hz if
you need to do this.
Noise reduction
When you are recording, the background noise of microphones, or
the noise from guitar amplifiers, etc., may be too loud. The DP-01FX
allows you to “gate” this noise, and only open the gate when the
input signal goes over a certain level. This only takes effect when
the
MULTI effect is enabled.
1 Press MENU , and then select the PREFERENCE menu.
2 Use the arrow keys to scroll to NSP :
Using a noise gate
like this sometimes
requires a little work to make sure
that you don’t accidentally cut off
quiet parts of a song. Before you
make a recording using the noise
gate, it’s a good idea to rehearse
the whole part to make sure you’ve
got the right gate level.
3 Set the level at which the gate opens to a value of: OFF (the gate is
always open), or from 1 (the gate will open easily, with very quiet
sounds) to 60 (a lot of force—a very loud sound—is needed to open
the gate).
DP-01_OM_E.book 63 ページ ２００５年６月１３日 月曜日 午後７時１４分