Advanced techniques – Tascam DP-01FX/CD User Manual
Page 29
Advanced techniques
TASCAM DP-01 Owner’s Manual
29
L
ocation
To move to a location mark
Press and hold the
LOCATE
key, and
briefly press and release the
REW
or
F FWD
key to move to the previous
or next mark in the song. This works while playing back, while
stopped or “winding”, but not while recording.
5
Alternatively, press and hold the
LOCATE
key for about a second to
show the location mark list:
Use the jog wheel to choose a mark (they’re listed in the order they
appear in the song) and press
ENTER
to jump to that mark.
You can’t undo this.
To delete a location mark
Stop playback (or recording) and locate to
the mark you want to delete (or a little after). Press and hold down the
SHIFT
key and press the
INSERT
(
DELETE
) key.
This is sometimes
called “trimming”.
To edit a location mark
If you made a mistake when you entered a
location mark, you can change the time of the mark.
1
Press and hold the
LOCATE
key for about a second to show the loca-
tion mark list.
The marks are
shown in the order
they appear in the song, not by
number.
2
Use the jog wheel to select a mark and press the
cursor key to select
it.
1/10 frame is 1/300
of a second—about
3.3 milliseconds
3
Use the wheel to move the mark backwards and forwards by 1/10
frame (the rightmost digit of the number). You can’t move a mark for-
ward past the next mark in the list, or backwards to before the previous
mark in the list.
4
Press
ENTER
when done (to return to the home screen) or
EXIT
(to
return to the mark list).
IN and OUT marks
These marks are used for setting the points at which automated punch recording
starts and ends and for repeat playback, as well as for track editing. You can set
these marks while playing back, recording, or while playback is stopped.
IN and OUT marks
are also used
(along with the TO mark, which is
set and used in the same way)
when performing track editing func-
tions.
Set IN and OUT marks by pressing and holding the
SHIFT
key and
pressing
IN
(
SET IN
) or
OUT
(
SET OUT
) at the appropriate points.
Locate to the IN and OUT points by simply pressing
IN
and
OUT
.
Fine-tune the position of the IN and OUT points by pressing and
holding
SHIFT
and pressing
TRACK EDIT
(
POINT EDIT
):
Edit the point, to 1/10 frame accuracy, using the cursor keys and the
jog wheel, in the same way as for direct location (“Direct location” on
page 28).
Press
ENTER
when done.
DP-01_OM_E.book 29 ページ ２００５年６月１３日 月曜日 午後７時１４分