Advanced techniques – Tascam DP-01FX/CD User Manual
Page 53
Advanced techniques
TASCAM DP-01 Owner’s Manual
53
Abou
t tra
ck edi
ting
You can change the following values:
Src. Trk
This sets the source track or tracks from which the section is
taken. Choose
1
through
8
to select an individual track. Choose
1/2
,
3/4
,
5/6
,
7/8
to select a pair of tracks. Choose
1-8
to select all tracks.
Dst. Trk
This sets the destination track or tracks into which the selected
section is inserted. What you can select here depends on what you have
selected for the source track. If you have selected a single track, you can
select tracks
1
through
8
here. If you have selected a pair of tracks (for
instance,
1/2
), you can only select track pairs here. If you have selected all
tracks (
1-8
), then this is the only option available to you here.
Press
YES
to perform the operation or
NO
to leave this screen.
OPEN
This function “opens up” a silent gap between the IN and OUT points
on the chosen track or tracks.
The source and destination are the same, and after the operation, the track
is split at the IN point, with the material which followed the IN point now
moved to follow the OUT point. The result is therefore longer than the orig
inal.
There is only one value that you can change:
Src. Trk
Select an individual track (
1
through
8
), a pair of tracks (
1/2
,
3/4
,
5/6
,
7/8
), all of the tracks (
1-8
) or all tracks (
ALL
).
Press
YES
to perform the operation or
NO
to leave this screen.
CUT
This function deletes the material between the IN and OUT points on
the chosen track or tracks and “closes up” the gap.
The source and destination are the same, and after the operation, the mate
rial between the IN and OUT points is deleted. The track is therefore
shorter than the original.
There is only one value that you can change:
Src. Trk
Select an individual track (
1
through
8
), a pair of tracks (
1/2
,
3/4
,
5/6
,
7/8
), all of the tracks (
1-8
) or all tracks (
ALL
).
Press
YES
to perform the operation or
NO
to leave this screen.
SILENCE
This function is equivalent to recording silence between the IN and
OUT points on the chosen track or tracks.
Material is deleted, but the length of the result is the same as that of the
original (the gap is not closed up, unlike with the CUT function).
There is only one value that you can change:
Src. Trk
Select an individual track (
1
through
8
), a pair of tracks (
1/2
,
3/4
,
5/6
,
7/8
), or all the tracks (
1-8
).
Press
YES
to perform the operation or
NO
to leave this screen.
Figure 2.8: Opening a gap
OUT
IN
OUT
IN
Figure 2.9: Cutting material
OUT
IN
IN
Figure 2.10: Inserting silence
OUT
OUT
IN
IN
DP-01_OM_E.book 53 ページ ２００５年６月１３日 月曜日 午後７時１４分