Tascam DP-01FX/CD - Manual (Page 37)

Advanced techniques
TASCAM DP-01 Owner’s Manual
37
W
o
rking in
bars & beat
s
Point editing Even when the screen shows positions in bars and beats,
location points are edited in minutes and seconds (“To edit a location
mark” on page 29), except that the bars and beats equivalent is also
shown.
When the LOCATE key is held down in “bars and beats” mode, the dis-
play looks something like this:
IN, OUT and TO
points do not show
the bars/beats value when being
edited.
Selecting a point to edit shows the bars and beats below the absolute
time value. The bars and beats cannot be set directly, but change,
together with the absolute time value, as the jog wheel is turned:
Metronome
To help you keep in time, the DP-01 provides an internal metronome
function and a MIDI metronome function. The internal metronome
function allows you to listen to the metronome on the DP-01, while
the MIDI metronome function generates a metronome output on the
MIDI interface.
1 Press MENU , use the DATA dial to select the MIDI menu, and press the
cursor key.
2 Select the METRONOME item, and press the cursor key.
When "INT" is selected at "Output" [internal metronome]
The DP 01's internal metronome (not an external sound source) can be out
put to headphones and LINE OUTPUT L/R.
The internal metro-
nome is not output
in the following instances:
• While the BOUNCE key is lit
• While the MASTER key is flashing
or is lit
Mode Select from RecOnly (only at recording) and Rec&Play (at recording
and playback).
IntLvl Set the output level of the metronome within the range 0 to 127.
(The output level cannot be adjusted on the MASTER fader.)
When "MIDI" is selected at "Output" [MIDI metronome]
This setting generates a metronome output via the MIDI interface. Gener
ally, percussion type sounds are used as the metronome. Any sound, of
course, can be produced.
DP-01_OM_E.book 37 ページ ２００５年６月１３日 月曜日 午後７時１４分