TP-Link TD-W8960N - Manual (Page 79)

TD-W8960N Wireless N ADSL2+ Modem Router User Guide
Wireless access can be filtered by using the MAC addresses of the wireless devices transmitting
within your network’s RADIUS. To filter wireless users by MAC Address, either permitting or
blocking access. If you do not wish to filter users by MAC Address, select Disabled.
¾ Disabled: Select this option to disable MAC Filter function.
¾ Allow: Select this option to enable MAC Filter function that allow wireless access by the
devices listed on this screen.
¾ Deny: Select this option to enable MAC Filter function that block wireless access from the
devices listed on this screen.
¾ Add: Click this button to add the MAC Address.
¾ Remove: Select the item of the MAC Address and click this button to remove it.
When you click the Add button, the pop-up picture shown below, and then you can type the MAC
Address in the MAC Address field.
)
Note:
The form of MAC Address must be “xx:xx:xx:xx:xx:xx”, like “00:13:0A:55:FF:09”.
Figure 4-90
When you finished making changes to the MAC Filter List screen, click Save/Apply to save the
changes.
4.5.4 Wireless Bridge
Choose “Wireless”Æ”Wireless Bridge”, you will see the screen of Wireless-Bridge settings
shown as below. You can configure wireless bridge features of the wireless LAN interface and
click Apply/Save button to save the current configuration.
72