TP-Link TD-W8960N - Manual (Page 36)

TD-W8960N Wireless N ADSL2+ Modem Router User Guide
Figure 4-21
¾ IP Address: You can configure the Router’s IP Address and Subnet Mask for LAN Interface.
• IP Address: Enter the Router’s local IP Address, then you can access to the Web-based
Utility via the IP Address, the default value is 192.168.1.1.
• Subnet Mask: Enter the Router’s Subnet Mask, the default value is 255.255.255.0.
¾ Enable IGMP Snooping: If you select the option, please choose the IGMP Mode: Standard
Mode or Blocking Mode.
¾ DHCP Server: These settings allow you to configure the Router‘s Dynamic Host
Configuration Protocol (DHCP) server function. The DHCP server is enabled by default for the
Router’s Ethernet LAN interface. DHCP service will supply IP settings to computers which are
configured to automatically obtain IP settings that are connected to the Router though the
Ethernet port. When the Router is set for DHCP, it becomes the default gateway for DHCP
client connected to it. Keep in mind that if you change the IP address of the Router, you must
change the range of IP addresses in the pool used for DHCP on the LAN.
• Start IP Address: Enter a value for the DHCP server to start with when issuing IP
addresses. Because the default IP address for the Router is 192.168.1.1, the default Start
IP Address is 192.168.1.2, and the Start IP Address must be 192.168.1.2 or greater, but
smaller than 192.168.1.254.
29